I wanted to see if I could get it as non-flashy as possible... well my car is mostly stock and even when I finish my engine project it will not surpass 400 flywheel horse power. Its modest and so should relfect that modesty with NO flash, NO ghetto chrome! So I tried to make it look like the stock plastic tube as much as possible! I ground off the cast logo and personally powercoated it - using my buddys system - black wrinkle ALSO powder coated the new C & L Mass Air Flow Sensor a 'high temp cast grey metal' powdercoat that was an experiment for use to use as it was a new powder / also first "high temp" type powder we used. I think came out great! Compare the Ford Stock Intake, the stock C&L and my modified tube.
20070502-mustang-Intake001.jpg
421.30 KB
421.30 KB
20070502-mustang-Intake002.jpg
407.72 KB
407.72 KB
20070502-mustang-Intake003.jpg
405.10 KB
405.10 KB
20070502-mustang-Intake004.jpg
389.06 KB
389.06 KB
20070502-mustang-Intake005.jpg
148.54 KB
148.54 KB
20070502-mustang-Intake006.jpg
222.90 KB
222.90 KB
20070502-mustang-Intake007.jpg
210.73 KB
210.73 KB
20070502-mustang-Intake008.jpg
157.67 KB
157.67 KB
20070502-mustang-Intake009.jpg
166.11 KB
166.11 KB
20070502-mustang-Intake010.jpg
201.28 KB
201.28 KB
20070502-mustang-Intake011.jpg
181.99 KB
181.99 KB
20070502-mustang-Intake012.jpg
185.81 KB
185.81 KB
20070502-mustang-Intake013.jpg
148.55 KB
148.55 KB
20070502-mustang-Intake014.jpg
158.38 KB
158.38 KB
20070502-mustang-Intake015.jpg
187.79 KB
187.79 KB
20070502-mustang-Intake016.jpg
209.31 KB
209.31 KB
20070502-mustang-Intake017.jpg
208.50 KB
208.50 KB
20070502-mustang-Intake018.jpg
194.73 KB
194.73 KB
20070502-mustang-Intake019.jpg
184.39 KB
184.39 KB
20070502-mustang-Intake020.jpg
222.46 KB
222.46 KB
20070502-mustang-Intake021.jpg
199.61 KB
199.61 KB